Rekup Logo
|
Try Rekup PRO
FREE
for 14 days

Shoulder Pain After Bench Press: Causes and How to Fix It

By the Rekup team · Published October 25, 2026 · 8 min read

Shoulder pain after bench press is usually an overloaded rotator cuff or biceps tendon at the front of the shoulder, from pressing deep with a wide grip and flared elbows, or from adding volume too quickly. It typically settles in one to two weeks if you swap the painful lifts for pain-free variations rather than stopping training. A pop with sudden weakness, bruising, or a change in the shape of the chest is different: get it checked promptly.

Where does it hurt? What each spot usually means

The shoulder is one of the most frequently injured regions in resistance training: up to 36% of documented injuries in one review (Kolber et al., 2010). Location is the fastest way to narrow down what you are dealing with. This table is a guide to what is likely, not a diagnosis:

Where you feel itWhat it often isTypical signsWhat to do
Front of both shoulders and chest, next dayMuscle soreness (DOMS)Dull ache, symmetrical, better once warmTrain as planned, it fades in 2 to 3 days
Front of one shoulder, deepIrritated rotator cuff or biceps tendonHurts at the bottom of the press, when reaching behind you, or lying on that sideModify pressing (below), build back over 2 to 3 weeks
Top of the shoulder, on the bony bumpAcromioclavicular (AC) joint painTender to touch on the point, hurts in dips and deep benchCut deep pressing and dips, see a physio if it persists
Chest or armpit, sudden during a repPectoralis major strain or tearPop, immediate weakness, bruising laterStop, get assessed promptly
Shoulder blade or between the bladesUpper back muscles, rarely the jointAche along the inner edge of the bladeUsually soreness or posture under the bar

The AC joint row deserves a note. In a classic series of 46 athletes with painful osteolysis of the end of the collarbone, 45 lifted weights as part of their training (Cahill, 1982). If the pain is on the bony point at the top of your shoulder and not in front, deep bench and dips are the usual suspects.

What to do in the first days

If it is soreness, you will feel clearly better within two or three days. If it is a tendon that has been overloaded, it should improve steadily week to week with modified training. Pain that is not starting to improve after two weeks is a reason to see a doctor or physiotherapist (NHS).

Why the bench press hurts your shoulder

The bench press loads the front of the shoulder hardest at the bottom of the movement, when the upper arm is behind the body. A review of shoulder injuries in resistance training identified two groups of risk factors: muscle and joint imbalances, and poor attention to technique (Kolber et al., 2010). In practice, it is usually one of these:

  • A wide grip with flared elbows. A wide grip shortens the range of motion, but places more stress on the front of the shoulder. A review on grip width suggests keeping the hands within about 1.5 times shoulder width to limit that stress (Green and Comfort, 2007).
  • Too much range when the shoulder is irritable. Lowering the bar until the elbows are far below the bench line takes the shoulder into its most vulnerable position. Clinicians who return injured athletes to the weight room modify grip, hand spacing, bar path and the start and end positions of the press first (Fees et al., 1998).
  • Losing the shoulder blades. When the shoulder blades are not pulled back and down, the shoulder joint absorbs what the upper back should stabilise. This often shows on the last reps of a set.
  • A volume spike. A new program, a bench specialisation block, or in CrossFit a week with bench, push-ups, dips and handstand push-ups. Each session is reasonable; together they add up.
  • Too little pulling. Weeks with plenty of pressing and few rows or pull-ups leave the muscles that stabilise the shoulder blade underworked.

The pec tear sits apart: of 365 published cases of pectoralis major injury, 48% happened during weight training (ElMaraghy and Devereaux, 2012). It is rare, but it is the one injury not to train through.

How to keep pressing while it settles

Most lifters do not need to stop pressing. They need a variation that loads the chest without irritating the shoulder. Try these in order and keep the first one that stays pain-free:

  1. Narrower grip. Bring your hands in a thumb's width or two and tuck the elbows to about 45 degrees from your body.
  2. Neutral-grip dumbbell press. Palms facing each other: many lifters with an irritated shoulder find this far more comfortable than the barbell.
  3. Floor press. The floor stops the elbows before the shoulder reaches the end of its range. Barbell or dumbbells both work.
  4. Board press or pin press. A shorter range from a set height, if you need to keep loading the barbell.
  5. Slower lowering. Three seconds down with a lighter load keeps control in the bottom position.

Use the same pain rule as for any tendon: up to 3 out of 10 during the exercise is acceptable if it settles within 24 hours and does not build from session to session.

A three-week plan to return to the bench

This is a practical progression for simple overload, not a rehabilitation program for a diagnosed injury.

  1. Week 1: calm it down, keep strength. Dumbbell floor press, 3 sets of 10, light. Band external rotations, 3 sets of 15, and band pull-aparts, 3 sets of 15, on most days. Rows or pull-ups as usual.
  2. Week 2: add range. Neutral-grip dumbbell bench press, 3 sets of 8 to 10. Keep the external rotations. Add push-ups on a raised surface if they are pain-free.
  3. Week 3: back to the barbell. Start at about half your working weight with a slightly narrower grip. Add load each session while pain stays within the rule above, and return to your previous weights over the following one to two weeks.

How strong is the evidence for exercise in rotator cuff problems? Honestly, mixed. A Cochrane review found that manual therapy and exercise may work about as well as injections or surgery for rotator cuff disease, but on low-quality evidence (Page et al., 2016). Progressive loading remains the usual first approach because it is low-risk and keeps you training, and a physiotherapist can adapt it if your shoulder is not responding.

Preventing shoulder pain from benching

  • Keep your grip within about 1.5 times shoulder width, elbows tucked at roughly 45 degrees.
  • Set your shoulder blades back and down before unracking, and keep them there on the last reps.
  • Do at least as much pulling as pressing over the week: rows, pull-ups, face pulls.
  • Add external rotation work twice a week, 2 to 3 sets of 15 with a band.
  • Count all your pressing, not just bench: push-ups, dips and handstand push-ups load the same shoulder.
  • Raise volume gradually when starting a new program or a bench-focused block.

If your lower back is what complains after heavy sessions, read lower back pain after deadlifts. For CrossFit athletes juggling pressing with everything else, how to recover from CrossFit covers the whole week.

In short

A dull, symmetrical ache in the front of the shoulders the day after benching is soreness. Deep pain in the front of one shoulder is usually an overloaded tendon: swap to pain-free variations, keep training around it, and return to the barbell over two to three weeks. Then fix the cause, usually grip width, depth or a sudden rise in pressing volume. For next-day soreness anywhere else, see how to get rid of DOMS, and for the bigger picture, how to recover faster between workouts.

Frequently asked questions

+Should my shoulders be sore after bench press?

A dull ache in the front of both shoulders and the chest the day after a hard bench session can be normal muscle soreness, because the front delts work hard in the press. Pain inside the joint, pain on one side only, or pain that started during a rep is not soreness.

+Why does the front of my shoulder hurt after benching?

Most often because the shoulder was loaded at the bottom of the press with the elbows flared and a wide grip, or because pressing volume rose faster than the shoulder could adapt. It is usually an irritated rotator cuff or biceps tendon rather than a tear.

+Should I stop benching if my shoulder hurts?

Stop the variation that hurts, not all training. Most lifters can keep pressing pain-free with a narrower grip, a neutral-grip dumbbell press or a floor press while the shoulder settles, then build back to the barbell over two to three weeks.

+How long does shoulder pain from bench press take to heal?

Simple overload often settles within one to two weeks of modified training. The NHS advises seeing a doctor if shoulder pain has not started to improve after two weeks; tendon problems that have built up over months can take longer to resolve.

+What does a torn pec feel like?

A sudden pop or tearing sensation during a heavy rep, immediate weakness, then bruising and a change in the shape of the chest or armpit fold in the following days. It needs prompt medical assessment, as complete tears are often repaired surgically.

Get this routine built from your own training

Log your workouts and Rekup estimates the load on each muscle group, shows when each one is ready again, and builds a recovery routine for the muscles you actually trained, from more than 130 movements.

Try Rekup PRO free for 14 days

Free plan available. Cancel the trial anytime from the store.

Download on the App StoreGet it on Google Play
Rekup recovery routine screen showing a glute smash with timer and instructions

This guide is educational and does not replace a diagnosis. If pain is severe, keeps getting worse or comes with the warning signs listed above, see a doctor or a physiotherapist.

Sources

  1. Kolber MJ et al. Shoulder injuries attributed to resistance training: a brief review. Journal of Strength and Conditioning Research, 2010.
  2. Aasa U et al. Injuries among weightlifters and powerlifters: a systematic review. British Journal of Sports Medicine, 2017.
  3. ElMaraghy AW, Devereaux MW. A systematic review and comprehensive classification of pectoralis major tears. Journal of Shoulder and Elbow Surgery, 2012.
  4. Cahill BR. Osteolysis of the distal part of the clavicle in male athletes. Journal of Bone and Joint Surgery, 1982.
  5. Fees M et al. Upper extremity weight-training modifications for the injured athlete. American Journal of Sports Medicine, 1998.
  6. Green CM, Comfort P. The affect of grip width on bench press performance and risk of injury. Strength and Conditioning Journal, 2007.
  7. Page MJ et al. Manual therapy and exercise for rotator cuff disease. Cochrane Database of Systematic Reviews, 2016.
  8. NHS. Shoulder pain.

Related guides

Rekup Logo
Download on the App StoreGet it on Google Play
Recovery guidesTerms of ServicePrivacy PolicyContact Us
Rekup® All rights reserved 2025.
Made with ❤️ by Singularite Agency